Kiểm tra & Khắc phục sự cốCâu 508 / 521
In a series circuit, 24 V is applied across a 4 ohm and an 8 ohm resistor in series. What voltage will a DMM read across the 8 ohm resistor?
a.16 V
b.8 V
c.24 V
d.2 V
Giải thích
Total R = 4 + 8 = 12 ohms, so I = 24 V / 12 ohms = 2 A. Across the 8 ohm resistor, V = I x R = 2 A x 8 ohms = 16 V (the 4 ohm drops the remaining 8 V). The larger series resistor drops the larger share of voltage.
Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- You must measure current on a circuit feeding electronic (nonlinear) loads such as LED drivers and VFDs. Which meter feature gives an accurate reading?
- A 6 ohm and a 3 ohm resistor are connected in parallel. What total resistance should an ohmmeter read?
- During commissioning you want to confirm that a metal equipment enclosure is effectively bonded. Which check best verifies a low-impedance bond to ground?
- A branch-circuit breaker trips instantly every time it is reset, with nothing plugged in. Continuity from hot to ground reads near 0 ohms. What is the most likely fault?
- Three parallel loads on a 120 V circuit draw 4 A, 6 A, and 5 A respectively. What total current should a clamp meter read on the feeder conductor?
- A non-contact voltage tester (NCVT) does not light up near a conductor you must work on. Before treating the conductor as dead, what is the correct action?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra