Kiểm tra & Khắc phục sự cốCâu 518 / 521
By mistake you clamp your ammeter around BOTH the hot and neutral conductors of a single-phase 120 V branch circuit that is drawing 8 A. What will the clamp meter most likely read?
a.8 A
b.16 A
c.Approximately 0 A
d.120 A
Giải thích
The hot and neutral carry equal and opposite currents, so their magnetic fields cancel when both are inside the jaw, giving a reading near 0 A. To read true load current you must clamp only one conductor. A non-zero reading around both would actually indicate leakage/ground-fault current.
Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Why does over-torquing a lug or terminal screw create a hazard, even though the connection feels 'extra tight'?
- A homeowner reports that throughout the house, some lights dim while others brighten, and the effect shifts as loads switch on and off. Which service-level fault best explains this?
- Two meters are both marked CAT III, but one is rated 600 V and the other 1000 V. What does the voltage number add to the CAT rating?
- A motor-control resistor of 15 ohms must carry 2 A during operation. What voltage drop will a DMM read across it?
- During commissioning of a new bathroom circuit, how should you verify a GFCI receptacle provides ground-fault protection?
- A 120 V heater is rated 600 W. What is the operating resistance of its element (assume purely resistive)?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra