Thoát nước, Nước thải & Thông hơiCâu 159 / 360
An indirect-waste standpipe receiving a domestic clothes washer must have a trap, and the standpipe height above the trap weir must generally be within what range?
a.6 to 12 inches
b.12 to 16 inches
c.18 to 30 inches (457–762 mm)
d.36 to 48 inches
Giải thích
A clothes-washer standpipe must be trapped and vented, and the standpipe usually extends between 18 and 30 inches above the trap weir. Too short a standpipe can overflow during the wash pump-out; too tall creates back-pressure and slow draining. The trap is set at an accessible height below the standpipe.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §804.0Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- When a primary roof drain could become blocked and allow water to pond on the roof, the code requires…
- A hydromechanical grease interceptor is typically installed…
- A small under-the-sink hydromechanical grease trap rated to PDI standards commonly has a flow rating such as…
- What distinguishes an 'air break' from an 'air gap' in an indirect waste installation?
- A combination waste-and-vent system is chiefly intended for…
- As a vent extends upward toward its terminal, its required diameter…
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra