Thiết bị & Bình nước nóngCâu 225 / 360
A plumber replaces a water heater in a finished basement over a slab where a leak would not damage anything below, but the local code still requires spill protection. If a drain pan is installed, its drain must:
a.connect directly into the sanitary sewer without an air gap
b.loop upward before discharging
c.be capped until a leak occurs
d.discharge by gravity to an approved location where it will be readily observed
Giải thích
When a drain pan is installed, its drain line must run by gravity to an approved discharge point where a leak becomes readily visible, so the problem is noticed early. It must not tie directly into the sanitary drainage system without proper separation. Visibility of the discharge is the key requirement.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §507.5Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Water hammer arrestors are installed on a water distribution system primarily to:
- An outdoor hose bibb (sillcock) must be protected against backflow by:
- Each fixture supply to a lavatory or water closet is commonly fitted with an angle stop primarily to:
- A water heater installed in an attic must be reached by a passageway and working platform. A typical minimum requirement is a solid, continuous passageway not less than:
- Cross-connection control in a potable water system is intended to:
- A floor drain located in a room that is used infrequently may lose its trap seal by evaporation. The approved way to keep the seal is to provide:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra