Đường ống gaCâu 254 / 360
A branch serves two appliances downstream: a 30,000 BTU/hr wall heater and a 120,000 BTU/hr furnace. In natural gas cfh, what demand governs that branch?
a.150 cfh
b.120 cfh
c.30 cfh
d.90 cfh
Giải thích
Add the two inputs, 30,000 plus 120,000 equals 150,000 BTU/hr, then divide by 1,000 to get 150 cfh of natural gas demand. That combined cfh is what the branch must carry at the design pressure drop. Sections closer to just one appliance carry only that appliance's demand.
Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- An appliance shutoff valve is being installed. Which condition satisfies the accessibility requirement?
- A gas furnace uses a draft hood and relies on natural draft to move flue gases up the vent. This describes which general appliance venting category?
- Why must clearances to combustibles for a single-wall metal vent connector and for Type B vent be respected during installation?
- A sediment trap is typically built from a tee and a nipple. What is a reasonable minimum length for the capped drip nipple so it can actually collect debris?
- A line pressure regulator on a 2 psi system has a vent limiter or vent connection. Where must a regulator vent generally terminate?
- When installing CSST, which document must be followed for support spacing, fittings, bonding, and physical protection?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra