Đường ống gaCâu 256 / 360
A line pressure regulator on a 2 psi system has a vent limiter or vent connection. Where must a regulator vent generally terminate?
a.Into the return air plenum
b.Into any interior wall cavity
c.To the outdoors, or be fitted with an approved vent-limiting device, so escaping gas cannot accumulate indoors
d.Directly into the appliance combustion chamber
Giải thích
If a regulator diaphragm fails, gas can escape through the vent, so the vent must terminate outdoors or use an approved vent-limiting device to prevent indoor gas accumulation. It may never discharge into a plenum, wall cavity, or combustion chamber. The vent opening must also be protected against blockage by insects or debris.
Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Why must clearances to combustibles for a single-wall metal vent connector and for Type B vent be respected during installation?
- A branch serves two appliances downstream: a 30,000 BTU/hr wall heater and a 120,000 BTU/hr furnace. In natural gas cfh, what demand governs that branch?
- A sediment trap is typically built from a tee and a nipple. What is a reasonable minimum length for the capped drip nipple so it can actually collect debris?
- When installing CSST, which document must be followed for support spacing, fittings, bonding, and physical protection?
- Which test medium is acceptable for pressure-testing gas piping?
- Why is it important to know that propane (LP) vapor is heavier than air when installing gas piping and appliances?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra