Đường ống gaCâu 258 / 360
Which test medium is acceptable for pressure-testing gas piping?
a.Air or an inert gas such as nitrogen
b.Pure oxygen
c.The fuel gas itself at full pressure
d.Chlorinated water
Giải thích
Gas piping is proof-tested with air or an inert gas such as nitrogen, never with oxygen, which accelerates combustion, and never with the fuel gas itself under test conditions. Water is not used because gas lines must remain dry and clean. Isolate or remove appliances and regulators that could be damaged by the test pressure before charging the system.
Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A sediment trap is typically built from a tee and a nipple. What is a reasonable minimum length for the capped drip nipple so it can actually collect debris?
- A line pressure regulator on a 2 psi system has a vent limiter or vent connection. Where must a regulator vent generally terminate?
- When installing CSST, which document must be followed for support spacing, fittings, bonding, and physical protection?
- Why is it important to know that propane (LP) vapor is heavier than air when installing gas piping and appliances?
- Compared with propane, how does natural gas behave if it leaks indoors?
- A sizing table (natural gas) shows 1/2-inch pipe carries 92 cfh and 3/4-inch pipe carries 190 cfh at the governing length. A section supplies a 40,000 BTU/hr wall furnace plus a 45,000 BTU/hr water heater. What is the smallest size that works?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra