Thoát nước, Nước thải & Thông hơiCâu 92 / 360
Over its length, the total fall of a trap arm must not exceed:
a.Two pipe diameters
b.One-half pipe diameter
c.There is no limit
d.One pipe diameter
Giải thích
The trap arm may slope at 1/4 inch per foot, but its total fall from the trap weir to the vent must not exceed one pipe diameter. If it drops more than one diameter, the vent opening ends up below the trap weir, which allows self-siphonage. Two diameters exceeds the limit, half a diameter is stricter than required, and the fall is definitely limited.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §1002.2Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A horizontal branch serves two lavatories (1 DFU each), one kitchen sink (2 DFU), and one bathtub (2 DFU). What is the total DFU and minimum branch size?
- A horizontal drain run is 80 feet long at 1/4 inch per foot slope. What is the total fall over the run?
- A 3 inch drain runs 48 feet at the minimum slope of 1/8 inch per foot. What is the total fall?
- For a 1-1/4 inch trap arm, the maximum developed length to the vent is:
- For a 4 inch trap arm, the maximum developed length to the vent is:
- A cleanout is required at:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra