A dishwasher mixes a chlorine sanitizing solution for the third sink. What concentration and conditions are correct?
a.200 ppm chlorine, water 110 to 120°F, contact time 30 seconds
b.500 ppm chlorine, water 35 to 40°F, and a full 60 seconds of contact time
c.10 ppm chlorine, water at any temperature, read on a quat test strip
d.50 to 100 ppm chlorine, water 55 to 100°F, contact time about 7 seconds
Giải thích
A chlorine sanitizing solution should be roughly 50 to 100 ppm, with water between 55 and 100°F and at least about 7 seconds of contact, and it is verified with chlorine test strips. 10 ppm is far too weak to sanitize, and quat strips do not read chlorine at all. 200 ppm and 500 ppm are above the range for a food-contact rinse, leaving corrosive residue, and water near 40°F slows chlorine's action badly no matter how long the contact runs. Only the 50 to 100 ppm combination sits inside all three windows at once.
Trích dẫn luật: FDA Food Code §4-501.114Luyện miễn phí toàn bộ 500 câu hỏi — không cần đăng ký.
Own the complete ServSafe Food Protection Manager guide — PDF + EPUB, $19.99 →
Câu hỏi liên quan cùng chủ đề
- What is the key difference between cleaning and sanitizing a food-contact surface?
- In a three-compartment sink, staff are hot-water immersion sanitizing without chemicals. What water temperature and time meet the Food Code?
- A slicer is used continuously to slice deli meats throughout a busy lunch. How often must its food-contact surfaces be cleaned and sanitized during that continuous use?
- Which backflow prevention method is considered the most reliable because it creates a physical gap that no back-siphonage can cross?
- In a high-temperature dish machine, what final rinse temperature is generally required to sanitize with heat?
- Where should cleaning chemicals and pesticides be stored in a food establishment?
Cập nhật gần nhất: · quy trình kiểm tra
Đội ngũ PrepPass · Đối chiếu với ServSafe Food Protection Manager Exam · Quy trình kiểm tra