Type I — Small Appliances第 93 / 240 题
A shop buys a new recovery machine to service small appliances. Recovery equipment manufactured after November 15, 1993 must meet which requirement?
a.It must be certified by an EPA-approved equipment testing organization
b.It must be painted gray with a yellow top
c.It must be rated only for low-pressure refrigerants
d.It must have no more than a 15-pound cylinder capacity
解析
Recovery and recycling equipment manufactured on or after November 15, 1993 must be certified by an EPA-approved (third-party) testing organization to meet the applicable recovery standards. This ensures the machine can actually reach the required recovery efficiency. Cylinder color rules apply to DOT recovery cylinders, not to the certification of the machine.
法律依据: 40 CFR §82.158免费刷完整 240 道题库 — 无需注册。
同考点相关题目
- A technician wants to speed up refrigerant recovery from a chest freezer by heating the compressor with a torch and rapping the tubing with a hammer. Which statement is correct?
- System-dependent (passive) recovery equipment may be used on which of the following?
- During recovery from a small appliance with a working compressor, a technician can only reach 82% recovery before the unit stops pulling down. What should the technician do to comply?
- A technician removes a bolt-on piercing valve after finishing recovery on a refrigerator. Why is leaving a piercing valve on the system long-term discouraged?
- While servicing a dehumidifier, a technician accidentally releases a small amount of refrigerant into the room. Which statement reflects the Section 608 venting prohibition?
- A technician is recovering from a small appliance using passive (system-dependent) equipment. To meet the required level, what must be achieved when the compressor is not operating?