Type III — Low-PressureQuestion 196 of 240
When handling a large recovery cylinder of R-11 removed from a chiller, the technician must remember to:
a.Fill it completely to save space
b.Store it on its side near a heater
c.Leave the valve open to relieve pressure
d.Fill to no more than 80 percent and keep it cool
Explanation
Even low-pressure refrigerant cylinders must never be filled above 80 percent by weight, leaving room for liquid expansion, and should be stored cool and upright below 125°F. Overfilling can lead to hydrostatic rupture as temperature rises. Always weigh the cylinder rather than guessing.
Practice all 240 questions free — no signup required.
Related questions on this topic
- A technician recovering R-123 reaches 25 mm Hg absolute but the reading rises back up after the recovery machine stops. This usually indicates:
- Which of the following is NOT a low-pressure appliance refrigerant?
- Excessive water in a low-pressure chiller can freeze and rupture tubes because low-pressure refrigerants:
- A high-efficiency purge unit on a chiller is often equipped with a purge-rate log because a rising rate:
- The deep 25 mm Hg absolute recovery requirement exists for low-pressure appliances because:
- Which practice is correct when leak testing a low-pressure chiller that is under a vacuum?
Last reviewed: · editorial process
PrepPass Editorial Team · Verified against EPA Section 608 Technician Certification Exam · How we review