Engine Repair (A1)Pregunta 1 de 120
A cylinder head is warped beyond specification. Which service is normally required to restore a flat sealing surface?
a.Replacing the head bolts only
b.Installing a thicker head gasket
c.Resurfacing (machining) the head
d.Retorquing the head while hot
Explicación
A warped head must be resurfaced by machining to bring the deck within flatness specification. A thicker gasket will not correct an uneven surface, and simply retorquing does not remove the warp. Excessive material removal, however, can raise compression and change valve timing on some engines.
Practica las 120 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- Technician A says a blown head gasket can allow coolant to enter a cylinder and cause white exhaust smoke. Technician B says it can cause bubbles in the coolant recovery tank from combustion gases. Who is correct?
- A valve that fails to seat fully will most directly cause which condition?
- On an overhead-cam engine, excessive valve lash (clearance) most commonly produces which symptom?
- Technician A says the PCV system routes crankcase blow-by vapors into the intake to be burned. Technician B says a stuck PCV valve can cause rough idle or oil leaks. Who is correct?
- A mechanic measures cylinder taper by comparing bore diameter at the top of ring travel to the bottom. This measurement is taken with a:
- Technician A says low oil pressure only at idle on a high-mileage engine can be caused by worn bearing clearances. Technician B says a worn oil pump or diluted oil can also lower pressure. Who is correct?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con ASE Automobile Certification Series (A1–A8) · Cómo revisamos