Service & TroubleshootingPregunta 92 de 110
When a heat pump is stuck in cooling on a heat call, which component is a prime suspect?
a.The condensate trap
b.The air filter
c.The reversing valve or its solenoid coil
d.The supply registers
Explicación
If a heat pump blows cold air on a heating call, the reversing valve may be stuck or its solenoid coil or control signal may have failed, leaving the system in cooling mode. The technician checks the coil, the control voltage, and valve operation. A stuck valve often requires replacement.
Practica las 110 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- When measuring the actual airflow of an installed system, which measurement helps diagnose a restrictive duct system?
- A capacitor that reads well below its rated microfarad value should be treated how?
- Recommended routine maintenance to preserve airflow and efficiency includes what?
- A technician measuring compressor amp draw far above the rated load amps (RLA) should suspect what?
- The most likely cause of no cooling when the thermostat calls but the outdoor unit is completely silent is what?
- An ECM (electronically commutated motor) blower offers what advantage over a standard PSC motor?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con California CSLB C-20 Warm-Air HVAC Trade Exam · Cómo revisamos