Core TradesCâu 151 / 700
On a roof slope of 4:12 or greater covered with asphalt shingles, the underlayment must consist of at least:
a.One layer, applied with specified horizontal and end laps
b.Two full layers regardless of slope
c.No underlayment when self-sealing shingles are used
d.A layer of rigid insulation board
Giải thích
For slopes of 4:12 and steeper, a single layer of underlayment lapped a set amount at horizontal and end joints is required, because water sheds quickly. Slopes below 4:12 (down to the 2:12 minimum) require a doubled underlayment. Underlayment is never omitted, and rigid insulation is not underlayment.
Trích dẫn luật: 2025 CA Residential Code §R905.1.1Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Under the California Energy Code, supply ducts run through an unconditioned attic must generally be insulated to a MINIMUM of:
- Without a booster fan, the MAXIMUM developed length of a residential clothes-dryer exhaust duct (before deductions for fittings) is generally:
- A secondary condensate drain pan or overflow provision under a cooling coil is required primarily to:
- The MINIMUM roof slope on which asphalt shingles may be installed (with a doubled underlayment) is:
- A simple gable roof has two identical planes, each measuring 40 ft along the ridge by 18 ft up the slope. How many roofing squares of material cover the roof (before waste)?
- In an open valley on a shingle roof, metal valley flashing is installed primarily to:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra