Core TradesCâu 88 / 700
A wet vent serves a bathroom group. The key characteristic of a wet vent is that:
a.It carries only air, never any drainage
b.It must be a separate pipe from all fixtures
c.It vents only the toilet
d.A single pipe serves as both the drain for one fixture and the vent for another
Giải thích
In a wet vent, a section of pipe acts simultaneously as a drain for one fixture and as the vent for one or more other fixtures in the same bathroom group, sized larger to carry both functions. It does carry drainage, is not a fully separate vent, and is not limited to venting the toilet.
Trích dẫn luật: 2025 CA Plumbing CodeLuyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A fixture drain is located far from any vent, and after installation the trap seals siphon out, letting sewer gas into the room. The MOST likely code violation is:
- An air admittance valve (AAV) is installed to vent an island sink where a conventional vent is impractical. The AAV must be installed:
- CALCULATION: A 3-inch horizontal drain pipe is installed at the common 1/4 inch per foot slope. Over a 40-foot run, how much does the invert drop from start to end?
- A garden hose is left submerged in a utility sink filled with soapy water while the faucet is on. This creates a cross-connection hazard because:
- Horizontal copper water piping must be supported at intervals so it does not sag and strain joints. Compared with copper, plastic (PEX or CPVC) piping generally requires:
- An island sink uses a special loop vent because there is no adjacent wall to run a conventional vent up through. This island (loop) vent works by:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra