Core TradesCâu 89 / 700
A garden hose is left submerged in a utility sink filled with soapy water while the faucet is on. This creates a cross-connection hazard because:
a.The hose could burst
b.A drop in supply pressure could back-siphon contaminated water into the potable system
c.The water will get too hot
d.The sink could overflow
Giải thích
A submerged hose forms a direct cross-connection; if supply pressure drops, back-siphonage can pull contaminated water into the potable piping. The remedy is an air gap or backflow prevention device. Bursting, temperature, and overflow are not the cross-connection contamination mechanism.
Trích dẫn luật: 2025 CA Plumbing CodeLuyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- An air admittance valve (AAV) is installed to vent an island sink where a conventional vent is impractical. The AAV must be installed:
- CALCULATION: A 3-inch horizontal drain pipe is installed at the common 1/4 inch per foot slope. Over a 40-foot run, how much does the invert drop from start to end?
- A wet vent serves a bathroom group. The key characteristic of a wet vent is that:
- Horizontal copper water piping must be supported at intervals so it does not sag and strain joints. Compared with copper, plastic (PEX or CPVC) piping generally requires:
- An island sink uses a special loop vent because there is no adjacent wall to run a conventional vent up through. This island (loop) vent works by:
- A contractor plans to join copper tubing to galvanized steel pipe directly. The BEST practice to avoid a common failure is to:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra