Core TradesCâu 90 / 700
Horizontal copper water piping must be supported at intervals so it does not sag and strain joints. Compared with copper, plastic (PEX or CPVC) piping generally requires:
a.Wider support spacing because it is stiffer
b.The same spacing as steel
c.Closer support spacing because it is more flexible
d.No support at all
Giải thích
Flexible plastic piping sags more than rigid copper, so it needs more closely spaced hangers to prevent sagging and joint strain. It does not allow wider spacing, does not match rigid steel spacing, and always requires support.
Trích dẫn luật: 2025 CA Plumbing CodeLuyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- CALCULATION: A 3-inch horizontal drain pipe is installed at the common 1/4 inch per foot slope. Over a 40-foot run, how much does the invert drop from start to end?
- A wet vent serves a bathroom group. The key characteristic of a wet vent is that:
- A garden hose is left submerged in a utility sink filled with soapy water while the faucet is on. This creates a cross-connection hazard because:
- An island sink uses a special loop vent because there is no adjacent wall to run a conventional vent up through. This island (loop) vent works by:
- A contractor plans to join copper tubing to galvanized steel pipe directly. The BEST practice to avoid a common failure is to:
- CALCULATION: A vertical drainage stack must accommodate horizontal branch offsets. A trap arm for a 2-inch fixture drain is allowed a maximum developed length. If the code table permits 8 feet for a 2-inch trap arm, and the layout requires 11 feet to the vent, the installer should:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra