Monitoring & QACâu 74 / 100
Which statement best describes the regulatory and standards landscape for sterile processing?
a.Only the Food and Drug Administration has any authority over reprocessing practices
b.Only state health departments set requirements for sterile processing departments
c.Standards such as ANSI/AAMI ST79 are legally binding federal law in every state
d.Multiple bodies apply: the FDA clears devices and their reprocessing instructions, OSHA regulates worker safety, CDC publishes guidelines, CMS and accrediting organizations survey practice, and ANSI/AAMI standards define recognized practice
Giải thích
Sterile processing sits at the intersection of device regulation, occupational safety law, public health guidance, accreditation, and voluntary consensus standards, and departments are held to all of them. ANSI/AAMI ST79 is a voluntary consensus standard rather than statute, but it is widely adopted as the standard of care and is cited by surveyors. Some states have added their own certification and staffing requirements, which supplement rather than replace federal and accreditation expectations.
Trích dẫn luật: CDCLuyện miễn phí toàn bộ 100 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A recall requires the department to trace every package from a suspect cycle. What information must the load record contain?
- A nurse reports that a tray opened in the operating room contained an internal chemical indicator that did not change. What is the correct action?
- How should the daily Bowie-Dick test cycle be run?
- What is the correct handling of the control biological indicator that accompanies a test lot?
- A sterilizer has just been relocated to a new position in the department. What testing is required before it processes patient loads?
- A recall is initiated after a sterilization failure. Which action is part of a proper recall procedure?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với HSPA Certified Registered Central Service Technician (CRCST) Exam · Quy trình kiểm tra