SeguridadPregunta 1281 de 1605
Before using or handling any electrical equipment or cords, workers should:
a.Assume all cords are safe
b.Visually inspect them for defects and damage, removing damaged equipment from service
c.Only inspect cords once a year
d.Wrap frayed cords in cloth
Explicación
1926.416 and 1926.405 require that worn or frayed cords and damaged equipment be removed from service. Daily visual inspection catches damaged insulation, missing ground pins, and defects before use.
Referencia Legal: 29 CFR 1926.416(a)(3)Practica las 1605 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- Lockout/tagout (LOTO) procedures are primarily intended to protect workers from:
- Before work begins near electrical circuits, if a worker could contact energized parts, the employer must:
- On construction sites, which system is required to protect workers using 120-volt, single-phase, 15- and 20-amp receptacle outlets not part of the permanent wiring?
- For cranes and equipment operating near overhead power lines up to 50 kV, what minimum clearance is generally required if the line is not de-energized and grounded?
- A tag applied during tagout must:
- Head protection (hard hats) is required on a construction site whenever there is a possible danger of:
Última revisión: · proceso editorial
Sen Lin, Fundador de PrepPass · Verificado con California CSLB Contractor License Law & Business Exam · Cómo revisamos
Revisado por Abraham Chen — Licensed California General Contractor (CSLB License #1101856 — verificar)